I just bought a micro mill from harbor freight last week. I am now ready to start converting it to CNC. I am a mechanical engineer so I'm not worried too much about the mechanical issues. However, I only know enough about steppers, drives, cnc software to be dangerous.

Does anyone have any suggestions on driver boards, software, etc??? I am wanting to be able to convert models from SolidWorks into finished parts.

Any help/advice would be greatly appreciated.

Jeff

I just bought a micro mill from harbor freight last week. I am now ready to start converting it to CNC. I am a mechanical engineer so I'm not worried too much about the mechanical issues. However, I only know enough about steppers, drives, cnc software to be dangerous.

Does anyone have any suggestions on driver boards, software, etc??? I am wanting to be able to convert models from SolidWorks into finished parts.

Any help/advice would be greatly appreciated.

Jeff

Even i am thinkin of doing the same.......can some one help please