Have anyone exploding views of milling head ( good ones.. )? I need those because machines
which I bought was taken into pieces. There some part broken, that's not problem, but about
200 parts are problem because I haven't clue how these
parts come together. If somebody can send pics about that to my E-mail...

johannesthelen@hotmail.com



Ps. My english are very funny... I'm sorry, I'm from Finland...
I REALLY hope that somebody understand..:)

I think the r2c3 manual, and possibly the btc manual have an assembly drawing
I have been in there before to replace the ballscrew, so if you have any specific questions, I am sure someone here can help

Hello Finland from South Carolina!
Email sent!
Bill
:)

Thank you very much!

Thank you once again, these milling heads ( in pdf.. )are not just
same model which I have, but this file helps me lot.
What is milling head type in my machine? Is it somekind J-type?
It's very similar but motor is upside-down...

the bridgeport purpose built cnc iron has a special head. Similar to the J, but like you say, the motor is upside down, the ballscrew is concentric with the spindle





I found an interact manual I didn't mind tearing the diagram out of, hope this helps

Yes, these was what I find. Thanks lot!
One question, then I stop bother.. Is this head compatiple
with normal J-type, I mean belts and bushings.
In other words, can I buy normal J-type repair-set without fear that it
not fit?