I am new to Surfcam.


This is a post for a Bridgeport ezpath lathe. It doesnt read any thread codes, except the G33.

What do I change here to make it incrimentaly move the x?



RevSigns # List of letters to reverse signs

UppercaseComments? Y # Y or N 'Require uppercase comments

AutoThread # Automatic thread canned cycle
G33 X[V] Z[H] F[Frate]
G33 X[v] Z[H] F[Frate]
G33 X[v] Z[H] F[Frate]
G33 X[v] Z[H] F[Frate]
G33 X[v] Z[H] F[Frate]
end

Drill # Drilling canned/manual cycle
G74 Z[Depth] F[Frate]
end