Guys, how do I change the direction of the handwheel output?

When I turn it clockwise for positive, it moves in the negative direction on X, Y & Z.


Thanks in advance.

you have to go into the parameters. password is "proto3- 3" i don't remember exactly where it is you'll just have to search unless some one else knows exactly where it is. Todd.........ps. becarefull in there.

Parameter page, got to setup, enter proto3, push enter and enter again. select the axis page, page down 4 times, it's in the middle. Says something like handwheel invert.
Mine's a Centurion 5 but if I remember correctly the Cent. 6 we had at wok was the same.
Probably a good idea to back up your parameters to a disk first.

Dave