I type my program into my milling machine by front panel.
Can I upload these data from milling machine to BobCAD??
I want to save these data on my PC.
Anyone can help me??:withstupi :confused:

Yes you can. You will need to set BobCAD up to receive. Then snd the file from the machine.

For more specifics you will need to make sure that BobCAD jives wuth the settings on your machine. That is, make sure that your Baud Rate, Data Bits, Parity and Stop Bits are set the same between the machine and the computer. You may need to adjust the settings on the computer to get all of the data, but it can be done.

Regards