venomx999
02-12-2007, 04:16 AM
I took apart a few printers. Using the rail panels to put up this foam cutter.
X-Y coordinate. I tested it on Mach2 software using a DFX conversion from TurboCad drawing. It got a little messed up since the converstion to G-code using a different plane system. ... Hoping someone can help me on configuring Mach2 for hot wire foam cutting.
X-Y coordinate. I tested it on Mach2 software using a DFX conversion from TurboCad drawing. It got a little messed up since the converstion to G-code using a different plane system. ... Hoping someone can help me on configuring Mach2 for hot wire foam cutting.