I am having trouble with my Allen Bradley control. Does anyone know where I can get a troubleshooting manual or guide for it. The screen says emergency stop and I cant clear it at all or is the E stop shot?

Does it have a pull up E-stop Switch?
if so on the machine i use to work with
there is a contactor that has to go in when you pull up that sw

actually I just figured it out. coolant pump was stuck and an overload reset button was out. THANKS

Hi
Iam looking for a electrical prints for a bridgeport cnc mill with a allen bradley 8400mp controller

Does anyone know how to reset the password on the 8400 MP, Somehow the password was changed and I can't get the machine going.
Thanks
Art

Art
you could remove the 2aa batters form inside clam shell (lower left corner)
but then you would loss the control parameters.

right the parameters down befor removing battery

I have the user manual for the 8400MP if you need the programing procedure.

does any one have a wiring diagram for the 8400mp.

ben

Ben,
Thanks for the input, I found a master password that allows you to run and change any of the current passwords,: ABBP, that's it.
Thanks again.
Art