does anyone know where i can get ezcam for my bp2 r2c3 with heidenhain control that doesn,t cost an arm and leg. if so please let me know
thanks Dar

You might be able to get a copy BUT it probably won't run due to dongle protection - if you get a used copy, make sure you get the dongle.

Besides, old versions of Ezcam are not supported anymore - they pretty much force the surrendering of an arm or leg to get an "upgrade".

"Upgrade" is defined as buy a new license if you don't have the original dongle.

thanks nccams maybe i should have stuck with my old mill

Ya know you might be able to find some old EZCam version 6 around still that won’t cost you an arm & a leg! Why? Because it’s so good people are still using it!
I recommend version 6.2.1 or 6.3. I still use my 6.2.1 now it’s been 15 years running! Excellent stuff. But you do have to get the dongle with it or it’s useless. Big daddy

EZCAM EZ-Mill/Turn Pro v14.1? anyone have copy of this version.

Ya I think I have a clean copy on my old Windows 98 but no dongle with it.
Big Daddy

It’s a free trial version. I could zip it up and e-mail it. Then after playing with it for awhile you could click on the register software and register the software & pay for it with EZCAM then they’ll send you the dongle (key). Big Daddy

Diddy I like to give it a try, send it over at newtexas2006@yahoo.com.

hey NewTexas it's version 14.5 will that still work for you?? Big Daddy

I like to have copy.