tmole
02-02-2007, 04:44 AM
Hi all,
My company has recently purchased a Bridgeport Interact 1 mk2 and i have been assigned the task of getting it up and running. Have got it all set up and a test program (designed in mastercam) ready for trialling.
I have made a RS232 cable but am not sure if the configuration is right, if someone can help me on this topic i would be greatful. i have a 25pin male for the interact end, and prefer a 9pin female for the pc end.
I also require help in the basics of communicating with the TNC (it is either 151 or 155).
Any help appreciated
My company has recently purchased a Bridgeport Interact 1 mk2 and i have been assigned the task of getting it up and running. Have got it all set up and a test program (designed in mastercam) ready for trialling.
I have made a RS232 cable but am not sure if the configuration is right, if someone can help me on this topic i would be greatful. i have a 25pin male for the interact end, and prefer a 9pin female for the pc end.
I also require help in the basics of communicating with the TNC (it is either 151 or 155).
Any help appreciated