|
View Full Version : RFQ for tapped aluminum rods Unabiker 02-01-2007, 04:44 PM I need some rods. Lots of rods. 7/16" dia 6061 T-6 aluminum, 5" long Tapped M6 on both ends. 15mm thread depth 500 per month. Please include material. pp-TG 02-01-2007, 06:36 PM You have a PM.... MrMold 02-01-2007, 11:22 PM I've PM'd you with my quote. ddprecision 02-02-2007, 12:39 PM You have a PM. Thanks. Unabiker 02-02-2007, 03:31 PM Thanks to everyone who has submitted quotes so far. I'm gonna leave this open until next Friday, then make a descision. eddie6675 02-02-2007, 07:06 PM Hello, You have a pm oh...material cost by the month not the whole thing....(in referance to pm) ricotututi 02-05-2007, 09:31 PM I need some rods. Lots of rods. 7/16" dia 6061 T-6 aluminum, 5" long Tapped M6 on both ends. 15mm thread depth 500 per month. Please include material. Can I have a print or the tolerance on the overall length , diameters and dimension for the thread length , finish requirements. please email me at rico22t@msn.com my company website is miponline.com victorinox76 02-05-2007, 10:22 PM I am located in Ontario, where is your location as shipping these parts could make a difference. www.niagaratools.com Unabiker 02-07-2007, 07:17 AM all dimensions are +/- .005" raw stock finish is fine parts will be shipped to Indianapolis, IN 46227 j-radkemachine 02-08-2007, 11:04 AM SENT YOU A PM ... YOU CAN REACH ME @ jasonradkemachine@valornet.com OR BY PHONE @ 254 - 576 - 2513 THANKS jkford96 02-08-2007, 11:14 AM Thanks to everyone who has submitted quotes so far. I'm gonna leave this open until next Friday, then make a descision. I need some rods. Lots of rods. 7/16" dia 6061 T-6 aluminum, 5" long Tapped M6 on both ends. 15mm thread depth 500 per month. Please include material. sending you a PM puller482 02-08-2007, 03:57 PM Sent you a private message ricotututi 02-08-2007, 09:33 PM I send you a PM with our quote merl 02-09-2007, 12:04 PM you have a PM fastolds 02-12-2007, 06:38 PM I was going to send a quote but your email is full. sraab928 02-13-2007, 08:59 PM You have a PM. puller482 02-20-2007, 03:26 PM Has this job been awarded yet? |