I`m trying to use the turbocnc program, i boot in dos, when i run the executable i get the message co-mathematic processor not found??

Anyone have an idea on this?

Thanks,
Alex

Are you using a 386 processor? You need a 486DX or better.

Gerry

I`m using Athlon XP2000.

Does i need a really old computer ro run this program??

Hmmm...that is a good one...you may want to let Dave know. www.dakeng.com

E

I had this very same issue with turbocnc using a 486DX running 100 megahertz. Plenty machine to run turbocnc. Same error message using my new laptop. Contacted Dave. He responded that his computer gave him the very same message. :rolleyes:
I gathered that the solution is to ignore the message and move on.
Mike