I found a nice thread a while back which addressed a bunch of concerns regarding machine requirements based on what was to be made. wood, aluminum, accuracy, etc.

It went into acme screw, ballscrews ground/rolled, rails, bearings, etc

i cant find it anywhere.. any ideas?? It had some good info.

nevermind.. found it about 5 seconds after posting (nuts)

Sir,

If it was a GREAT thread, can you tell us where it is???

Regards,
Jack C.

Sir,

If it was a GREAT thread, can you tell us where it is???

Regards,
Jack C.

as soon as a find it again, ill post it. haha