alain aleman
12-26-2006, 11:47 AM
Hi guys, somebody knows how configurated mcx to send a program on my HAAS lathe?, i try a lot of times but i canīt do that.
Thank you for your time.
Alain
Thank you for your time.
Alain
|
View Full Version : how configurated mastercam x to send a program? alain aleman 12-26-2006, 11:47 AM Hi guys, somebody knows how configurated mcx to send a program on my HAAS lathe?, i try a lot of times but i canīt do that. Thank you for your time. Alain tobyaxis 12-31-2006, 02:59 AM Hi guys, somebody knows how configurated mcx to send a program on my HAAS lathe?, i try a lot of times but i canīt do that. Thank you for your time. Alain You have to have the correct Communication settings such as Baud Rate, Comm Port, Data Bits, Parity, etc. This information will be in your HAAS Manual. Do you have a Floppy or RS232 Cable? |