kbcnc
04-04-2003, 09:25 PM
Hello,
Does anyone have information or know of a website for G & M codes for a Fanuc 0T Control. The Control is on a Johnsford CNC Lathe (if it makes any difference.) I need information on the G70,G71,G72.....etc Repetative Cycles too. Also, does anyone know the parameter for enabling the work offsets (G54-G59) on this control?
Does anyone have information or know of a website for G & M codes for a Fanuc 0T Control. The Control is on a Johnsford CNC Lathe (if it makes any difference.) I need information on the G70,G71,G72.....etc Repetative Cycles too. Also, does anyone know the parameter for enabling the work offsets (G54-G59) on this control?