I have a dumb question i cant seem to figure out how to mill a a cirular pocket on my mori mv-40 i have never had a fanuc controlled mill

not sure how different your machine is, but here is how i do it for an mv-40

N1T1M6
G0G90G55X0Y0S5000M3
G43Z.1H1M8
G01Z-.5F20.
G41X-1.00D11
G03I1.
G0G40X0Z.1M9

any questions let me know

hey on your mv 40 do you have problems with your door interlocks i have to run an m99 at the end of a program cause if i run an m30 it says i have to open door at least once well some one jacked up the interlock so i was just wondering if you had any ideas thanks

Try this.
turn on the main power
make sure the interlock is turned to valid and the door is closed
turn on the machine( e stop and front on off)
turn the door interlock to invalid and open the door, interlock should be flashing
try to zero return the axis with the door open
this should work.

thank i will give that a try