Hi I'm loking for an edgecampost for dialog4 controll of deckel. If anyone have to an other of the dialog controllers that would be a start.

I also have an example that could be a base for constructing a post.

$%3
%
($%3 /000000)
N1 G0 X+0 Y+0 Z+5.
N2 G17 T1
N3 G0 G64 X+0.23 Y-.625 Z+1. F16.0 S+3150 M8
N4 G0 X+0.23 Y-.625 Z+1.
N5 G0 Z+0.1
N6 G81 F16.0 S+3150 Z-.3573 G4 F.0
N7 G0 Z+1.
N8 G0 X+0.23 Y+0.625 Z+1.
N9 G0 Z+0.1
N10 G81 F16.0 S+3150 Z-.3573 G4 F.0
N11 G0 Z+1.
N12 G0 Z+5. M9
N13 G17 T2
N14 G0 G64 X+0.23 Y-.625 Z+1. F15.8 S+3150 M8
N15 G0 X+0.23 Y-.625 Z+1.
N16 G0 Z+0.1
N17 G82 F15.8 S+3150 Z-.9599 Z-.125 Z+0.015 G4 F.0
N18 G0 Z+1.
N19 G0 X+0.23 Y+0.625 Z+1.
N20 G0 Z+0.1
N21 G82 F15.8 S+3150 Z-.9599 Z-.125 Z+0.015 G4 F.0
N22 G0 Z+1.
N23 G0 Z+5. M9
N24 G0 X+0 Y+0
N25 M30
?
0000

The first part is the type of program "$" is inch program, if the program is metric then the first character would be "&".

The next part is the program number. "%3" in this case the program was number 3.

Second line "%"

third lineis a comment line enclosed with "()" write as shown with repeat of program number slash and 6 zeroes.

Program body...................


end of program to always have "?" after last data line. Followed by a line with "0000"

I assume the S+3150 is the spindle speed. So S-3150 must be reverse since I diodn't see an M3 M4 for forward/reverse.

Do you have to have the S+3150 on every drilling line?
What does the G64 do?

Mike