We have to mills with centurion 7 controls. On the RW20 when verifying the tool path it sorta paints in the tool path while cutting the VM30XP does not it just shows the cutter following the tool path. Is there a setting to change this in the control ? Also can you change it in he offline programing software ?
Thanks
Bill

under parameters, setup, level, type in proto3 then level 3 go to misc look for special flags and set it to 016

This can be done on the offline as well.

MHolden
Thanks. I was looking in there and did not know where to change it worked
Thanks again
Bill