Hello:
I have mastercam X and mastercam9. I am programming for a new VTL
(2 axis). I used a post processor for a lathe program and all my X values are minus. Can anyone help me figure out how to modify the post so the X values are plus. The machine configuration is sindle down/turret right.
Thanks.

For verison X I think you can change this in your machine definiton, Im not sure what line in your post you have to change to force (+) x vaules.

HTH

Thank you for your response. In MC 9, when I backplot the values show positive but post out minus. In MC X, backplot shows zero but still post minus.
In both version the machine definition is for VTL. In backplot and verify, it shows as on a vtl, spindle down.
Anyway, thank you very much.

Hi.

I have an Anilam 3000M 3 axis controller and I am using Mastercam 9.1, do you know if there are any post procesor in this site.

because I am using the MPAN113X.PST post.

but have problems when I want to work with ZX.

thanks for your help

Ask your reseller for Mastercam ... he/she will be able to help you.

Ask your reseller for Mastercam ... he/she will be able to help you.

WOW!, that is extremely helpful.