Does anyone have listings of casting suppliers in Canada? I'm looking at maybe casting a couple pc's of alum but don't have anything to do it w/ as of yet. I'm looking for suppliers for refractory and crucibles and sand etc.. I've got lots of old trany's and engines which I plan to bash up into smaller pc's and re-cast into something usable.

Thanks!
Jerry

I'm looking for suppliers for refractory
Jerry

Try this link for refractory materials in Ontario.
http://www.pshcanada.com/kilnbuilding.htm

Thanks Weldtutor... I took a look, unfortunatly it looks like that site is more for pottery and smaller stuff, they only sell fire bricks not a pourable [like cement] refractory.. Look's like I'll have to keep looking..

Jerry

Jerry This link might help for your supplies.
http://www.synergetic.on.ca/
It is an associate of PSH, who do in fact supply
castable refractories, but you need to send them an email to request info for items not shown in their catalogue & web listings.

Hi Jerry,
Check out Clayburn Industries Ltd.
Clayburn Refractories Ltd.
They have an outlet in Ontario. Phone: (905) 892-8861
Their head office is:
33765 Pine Street
Abbotsford, BC Canada V2S 5C1
Phone: (604) 859-5288; (604) 526-4211
Fax: (604) 859-0424; (604) 859-2923
Internet: www.clayburngroup.com
Also for Refractory mortar and brick look at A.P. Green products they are readily available in Canada.
Tig

Does anyone have listings of casting suppliers in Canada? I'm looking at maybe casting a couple pc's of alum but don't have anything to do it w/ as of yet. I'm looking for suppliers for refractory and crucibles and sand etc.. I've got lots of old trany's and engines which I plan to bash up into smaller pc's and re-cast into something usable.

Thanks!
Jerry
Where are you from Jerryflyguy. I'm in Ottawa area if that helps you out any.

Luke

I'm a long ways away Luke, I'm located in Sask. so pretty much far away from anyone who sells this stuff.. [or so it would appear] I've got a couple email out to people, we'll see how it goes. I might just put this whole casting thing on hold until I am better set up to do it.

Jerry