Does anyone know of a post for a practical cnc plasma/router table
thanks
teacher

Have you checked with your Mastercam Reseller yet? They most likely will have something for you.

I called Mastercam and they are working on one for me its a farley simple code.
I used a generic HAAS post suplied in MCX
F100
G0 x--y--
G1 X--Y--
G2 X--Y--I--J--
G3 X--Y--I--J--
Each line of code needs a G comand, G0 is interpited as torch off, G1,G2,G3, torch on. It's easy to edit the code on a small prg. but on a large file it sucks.
Tnaks for the reply.
Teacher

I called Mastercam and they are working on one for me its a farley simple code.
I used a generic HAAS post suplied in MCX
F100
G0 x--y--
G1 X--Y--
G2 X--Y--I--J--
G3 X--Y--I--J--
Each line of code needs a G comand, G0 is interpited as torch off, G1,G2,G3, torch on. It's easy to edit the code on a small prg. but on a large file it sucks.
Tnaks for the reply.
Teacher


The bright side to this is that at least you will have a post you can use.

Teacher,
Do you have a post but it is not putting in The G0, G1 G2 etc.... on each line.
if this is the case send the post I will look at it for you.

could you help a man with a post processor for a routermast 52 by camtech it is running now but sometimes i cant make it cut a simple arc im using mastercam 8.11 with a post processor mpfan or mpfadal2