Nigel_B
10-18-2006, 05:20 AM
Hi All
Does anyone know of an Australian supplier of breakout boards?
Not just a set of terminals to connect to a D25 but an isolating board that stops the PC being cooked.
I know they are avalable from the States, but does anyone here have them?
Nigel
belli
10-18-2006, 11:29 AM
Hi Nigel,
Not in Aus. but am happy to mail them if you wish. www.cncdirect.co.za
Regards
Greg
Electramech
02-13-2008, 10:30 PM
Hi,
The only australian supplier of Breakout boards I have found so far is Oatley Electronics, who sell a kit K142A. It doesn't have Optocoupler isolation but there are two handy relays to use with a Spindle Motor or whatever. It's cheap too.
I have started designing a Circuit Board for a opto isolated breakout board, especially to use with Mach 3.
Cheers,
David
tumutbound
02-14-2008, 12:34 AM
You might try Ocean Controls, they sell a number of motor controllers and may have breakout boards as well.
http://www.oceancontrols.com.au/
Regards
Geoff
jallitt
02-17-2008, 09:32 PM
I just ordered one of these from ocean controls.
KTA-192 1 AUD$ 35.00 AUD$ 35.00
Parallel Port
Interface card
asembled
Lets see how long it take to get from AU to NZ.
You might try Ocean Controls, they sell a number of motor controllers and may have breakout boards as well.
http://www.oceancontrols.com.au/
Regards
Geoff