What is the M code for bringing the tool probe arm down? I don't have a button. I know it's not a pulldown either.

phoodieman

There should be button for that ???
If it is M code programmed you should found it from "Electric manual".

There isn't, but the arm has been brought up and down with an M code. I just can't remember what it is.

I can get it until monday, but there should be a switch for manually swinging arm down.
Any one that uses automatic tool compensations funktions on a produktion lathe? Looks quite cool when the quicksetter arm swings down and the tools moves with rapid and slows down just before messurement..

M80 /m81

Thank you. Worked right away.

Phoodieman

Are u using the automatic tool compensation funktion? ( G37/G36)