Hi all,

You are welcome to download "ExcelCutR3" (~500kb).
This new released support 'Home switch' & 'Limit Switch'.

More info at http://www.excelcut.netmyne.com .

Cheers,
arman

Arman,
Look at the program and it looks like the X and the Y need to move the same travel per mm
I have different screws, 18t X and 20 T Y so guess I can't run the software.
thanks
Bobb

hi bobb,

the software still perform the cut but will give u unexpected results.

for me its not a good idea to have diff size screw on x & y axis. but if you preffer that way then the source code is available. only minor changes.

regards,
arman

Arman,
thanks you for quick reply.
I am not programer so will have to pass.
foamworks is also the same.
gmfc, will let you have different X an Y, this is what I use now but was looking at all the programs to check them out.
Keep up the good work.
Regards,
bob

its still having alot of bugs...... :P
but its a nice program once its done.

hi venomx999,

thanks for your response.
since the program is an experimental or "just working example" bugs are expected. As for me the program served me well for cutting zagi shape wings (my favorite flying model). I'm more than happy if you could list out some of the bugs (if not all) that you encounter. suggestions are also welcome.

rgds,
arman