I had a problem with my servo motors. Replaced both x and y axis. Now I can't get it to run a program.Has anyone had this problem? It's a Dynapath 20 control. I can get the program to position but spindel won't start at normal speeds. It will turn at around 50 rpm.

Hate to see no one helping on this, but 1st try 3S@ 414-570-9530, and talk to Dan. They bought The tree parts inventory when Tree went down. They all were employees, real good guys maybe they know some one who can help. Also, there are some Tree 325 owners on the " Manufacturing Forum" and I see lots of them helping each other with control problems.

Adobe (old as dirt )