|
View Full Version : Troubleshoot DNC phoodieman 09-14-2006, 07:53 AM I'm trying drip feed to a Lagunamatic 3 axis mill with a desktop PC. I have the serial connection hooked up. Mastercam is sending the programs, but the controller says it doesn't have communication. It's a Dynapath controller. Any tips? phoodieman blksmith 09-16-2006, 01:24 PM First thing I would check is to be sure your comm ports are set the same on both cnc and pc motomitch1 09-16-2006, 02:50 PM Is the controller set in the rs232c mode? Green Button 09-20-2006, 02:49 AM Cable problem ? Please check: cadem.com phoodieman 09-20-2006, 08:38 AM Cable is good. Pinout is right. The controller is ready. I think it might be settings in the PC, but everything seems to be right. I'm stuck..... Phoodieman motomitch1 09-20-2006, 05:33 PM Is it a Dynapath 20 controller? frogier 09-21-2006, 01:44 PM Do you load your programs using this desktop? |