Hi All,

This is my first post to the CNCZone. I find it a bit difficult to find my way around. I was looking for the Aussie suppliers link page, but no luck :(

Anyhow, I've been involved in CNC for about 8 to 10 years. I have a Taig Lathe (On the way to being CNC), a Taig CNC Mill plus an Asian import 7x14 CNC ready lathe that I am currently converting. (If only I had enough time)

I supply a number of products to the CNC community; including an Upgrade board to the older Taig Cnc controller, a Modbus I/O board targeted at Mach3 but will work with any Modbus master. There is also the DigiSpeed controller that produces an Isolated 0-10Vdc signal for controlling VFDs and DC motor controllers. Plus a few other bits and pieces.

If you are interested in finding out more, have a look at: http://www.homanndesigns.com

I am also able to assist in people in there conversions or producing "one off" peices of equipment. As an example I built in Tool Turret modules into the ModIO controller for a large Mazak lathe in Perth plus a turret controller for an Emco CNC Lathe.

By the way, I'm located in Melbourne.

Cheers,

Peter.