Hello All,

I'm looking for the pinouts (db9 to db9) for my tree mill w/Anilam control
and any other info, to get this thing hooked up to the pc.
I've checked baud , etc to make sure they are the same on each end.
But I'm not getting anything ( using Cimco Editor for transfer )which works on the other machines . Thinking it must be something simple (which is why I can't figure it out)
I called Anilam waiting for call back
Thanx
Joe

Just got off the phone with Anilam guys

they said just switch 2 & 3 on one end of cable

I did that and it worked

Thanx Anilam

Joe