gbowne1
08-14-2006, 01:39 PM
I need to make and/or have made a die set that holds 28xx punches and dies made by CE Tooling in a single station setup. They are the same type used in WA Whitney presses.
Both the punch and die holders must be indexable to 1 or 5° increments throughout 360°.
My die space is 2-1/2ft L-R and 1-1/2ft F-B.
I have a DWG/DXF of a die set that would be good to use as the base platform of the design.
Gregory Bowne
Seattle, WA
gbowne1@yahoo.com
Both the punch and die holders must be indexable to 1 or 5° increments throughout 360°.
My die space is 2-1/2ft L-R and 1-1/2ft F-B.
I have a DWG/DXF of a die set that would be good to use as the base platform of the design.
Gregory Bowne
Seattle, WA
gbowne1@yahoo.com