Hello,
I recently purchased a used Okuma LB15 cnc lathe. Does anyone know the RS-232 parameters for this machine? Even a close guess will get me started.

Thanks!!!!!!!!!

Hi
Do anyone know about ADMAC ON NEW OKUMA MACHINES.
PLEASE REPLY
THANKS

You can e-mail directly: kevin@cnctechnicalservices.com, and I can send you the parameter settings I use. I assume you have an OSP5000/5020L control?

Do you mean the IGF programming or the stand alone ADMAC PC software?

The ADMAC software contains the IGF component (boy id love to have that, can I borrow $10,000?).

RS-232 Info

Cheers,

I have a copy of a manual written by Okuma that contains comprehensive information on RS232 communications for Okuma machines if you are interested? It is at work and I can scan it for you. Drop me a line if interested.
Regards
Brian.

Hey broby,
Could you post the error codes and what they mean?

The manual I was refering to is too large to attach in the forum... (only 1.7Mb) :(
Send me a pm with your email address and I will send you a copy direct.
If you have a specific error code, could you post it here?
I may or may not be able to assist.
Cheers
Brian.

I have a copy of a manual written by Okuma that contains comprehensive information on RS232 communications for Okuma machines if you are interested? It is at work and I can scan it for you. Drop me a line if interested.
Regards
Brian.

I Broby. I would like you quote me a copy of hte OSP5020L or similar RS-232 Pc to control transmission programs.. thanks a lot for your response!!!