Does anyone have any experience with this new download. I spent all day yesterday along with help from Brian B and we never did get the config correct, or there is a bug in this version.

I can set my direction in homing and when I make a change to any axis everything reverts back to the original settings. If I hit a limit, they revert back, if I reboot they revert back. I cannot get them to stay persistant.

Any suggestions?

Mike

Here's the link to the post about my (short) experience with Mach3 Dev. Ver. D1.90.065: http://www.cnczone.com/forums/showpost.php?p=177394&postcount=2. There was another version of Mach3 that I wound up spending more time tweaking than cutting. Unfortunately I don't recall the version.

I much prefer Mach3 Dev. Ver. 1.90.051 as noted in this post: http://www.cnczone.com/forums/showpost.php?p=171045&postcount=16

I'd suggest you return to the version of Mach3 you were using prior to installing 1.90.065 and wait for the next release.


Just my 2 cents,

HayTay

Haytay I have never used V3. In addition I have to have the lates version to do some beta testing on a plugin for Artsoft. I may not get to do that till next week though. We'll see.

Mike