I just thought I would let people know that EMC2 now has all the features required for plasma cutting with Torch Height Control.
Some of these features are still experimental but will be stable and shipped with EMC version 2.1 along with a sample config (my own table).


The configuration is made for:
CandCNC MP1000-THC/THC-500 http://www.candcnc.com
Bob Campbell/Jim Cullins THC 300 http://www.campbelldesigns.com

For more information see:

http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?Torch_Height_Control


Yours

Jarl
http://dallur.com