Wondering if there is a pre-existing tool library of router bits more akin to wood working for V9. I have created a few on my own but I guess I am just lazy and want to make it easy.

Mike are you useing Mastercam mill?
There is mastercam Routor that contains a hole libary.

I will have to see about exporting out from Router to Mill.

Using Mill, that would be cool if you could. Mike

Ya, I would be interested in that too please if possible.
Thanks. :)

I have found that I can pull my libary from router to Mill and use this tool list...

If you have the new disk you can tell during the install the router software.
Of couse sense you key will not let you run Router ,but you can go to NC utiltis and change the libary and go to the tools dir in router.

grab te libary you want...

Hope this helps.