CRFultz
06-27-2006, 05:54 AM
VCarve Pro allows for the import of PhotoVcarve projects so you can position the image anywhere onto the material and add text and graphics.
-
This is a simple layout of my new Harley Davidson 2006 Low Rider.
Depth of cut was about .03 using a .062 60 degree cutter.
Cut time was about 40 mins at 25ipm.
Combining the two pieces of software opens up all kind of creative possibilities which I haven't even begun to dabble with. This software package and Mach 3 is enough to keep me busy for a long time. :)
-
The wood was 1/2 inch Maple, I put on two coats of Minwax poly before the cut and applied Jacobean stain after the cut and then wiped it off.
Chuck
-
This is a simple layout of my new Harley Davidson 2006 Low Rider.
Depth of cut was about .03 using a .062 60 degree cutter.
Cut time was about 40 mins at 25ipm.
Combining the two pieces of software opens up all kind of creative possibilities which I haven't even begun to dabble with. This software package and Mach 3 is enough to keep me busy for a long time. :)
-
The wood was 1/2 inch Maple, I put on two coats of Minwax poly before the cut and applied Jacobean stain after the cut and then wiped it off.
Chuck