Im new to the forum and I have myself in quite a bind.

I have a Daewoo Puma 240M and I believe the control on it is a fanuc 21iT, I know its an i series control, dont know which one exactly.

anyway I run this lathe under gibbscam and I need a post processor for it, I have mastercam if I really need to use it.

if anyone has any kind of way that I can get or make myself a processor, please let me know,

thanks

Jack

I need a post for mastercam X for a puma 240 can you help?

I need hellp to find a post processor for gibbs fanuc 21iT.

Need help!! I have a Daewoo Puma 700M W/Fanuc 21i-TB control.I need a post processor or some help editing the Mastercam X MPLFAN.pst. I've changed all the m-codes,but I cant find where remove the decimal point for the Q value. Thanks for any help.