sundara
11-23-2003, 07:19 PM
I have an older Charmilles Robofil wire EDM that I'm trying to get running. It's a model CH-552 with type #2222 control & type #1222 power supply. When I use the commands MOV & MOR (basically like MDI move absolute & realtive) the machine works & cuts fine. When I use the commands CTA & CTR (manual machining absolute & realtive) the tank fills, power supply kicks in, the wire starts going, everything basically looks like it's kicking in to run but the machine will not move. If anyone has any experience with these machines I'd really appreciate any help offered. I haven't worked on one of these before so it may be something really simple that I don't know about. Thanks!
wireguy
03-20-2004, 11:58 AM
do you have a tec file loaded when you use ctr are you telling it which axis you want it to travel in
IS THERE A PEICE OF WIRE SOMEWHERE SHORTING THE MACHINE OUT??? CONTACT CHARMILLE THEY HAVE GREAT SERVICE
KTDB2003
07-19-2007, 02:34 PM
Do You Still Have Rebofil 552 Edm I Just Got One With No Manual,do You Have Manual I Need Your Help
Thank You
Khanh-vu
KTDB2003
07-19-2007, 02:35 PM
Do You Still Have Rebofil 552 Edm I Just Got One With No Manual,do You Have Manual I Need Your Help
Thank You
Khanh-vu
G00X0.0Y0.0
09-04-2007, 02:17 PM
Hi,
I work on a 20 year old Charmilles Robofil wire EDM too ... but only from a week ago ... I gotta tell, the machine is a lil bit tricky ... 4 example .. my upper water pump wont start if i don't insert or just check the technology or wire every time i start the machine ... try that ... if i hear something new i'll let u know..
paul.
G00X0.0Y0.0
09-04-2007, 02:19 PM
CTDB2003 i have the complete manual ... but it is in german .. and it's at work
G00X0.0Y0.0
09-04-2007, 02:21 PM
One question ... do u write ur code by hand or use converter ... and if u do use a software wich one ...