I obtained a used copy of Mastercam X recently. It seemed like a really good deal at the time, but now I am finding out that Mastercam will not help me out at all. I need to obtain a post processor for my Anilam 3300MK. I have no clue how I can go about this. I just figured on having to pay Mastercam a small amount for this post, but this is definently not the case. Any help would be greatly appreciated. Thanks!

If it helps, I am also using a HASP 4 dongle.

I Might have one send me an email.

Mike

G'day
If you have a post that works well from an older version of M'c you can use the post translation function or the Chooks to update postprocessors. It works pretty well. You may have to make minor adjustments afterwords to get it 100%.
Good luck :) :)
John

Hi John:

I seen your post on the forum at CNCZone about the about upgrading a MC9 Anilam S1100 post to work with MC10. I was wondering if you could forward me a copy of this.
I have an Anilam S1100 control, it's a beautiful control however getting a post is difficult.

Thank you

Sam