Hi guys.
I've successfully installed BDI 2.20, on an Advantech PPC-102T. This computer is equipped with an Elo touchscreen, that would be verry nice to get working. I have been at the Elo website to see what they reccomend, but their instructions are only for Redhat higher than Rev.7.

These are their instructions:

Add the following line to the "ServerLayout" Section:
Inputdevice "touchscreen1" "SendCoreEvents"

Add the following section to the "Inputdevice" section:
Section "Inputdevice"
Identifier "touchscreen1"
Driver "elographics"
Option "Device" "/dev/ttyS0"
Option "AlwaysCore"
Option "screenno" "0"
Option "MinimumXPosition" "600"
Option "MaximumXPosition" "3600"
Option "MinimumYPosition" "600"
Option "MaximumYPosition" "3600"
Option "UntouchDelay" "3"
Option "ReportDelay" "1"
EndSection

But the problem is that there are no section "ServerLayout" in Rev 6.2, so where do i put it????

And yes, I'm rather a noob with Linux.

Solved :)

Found the correct driver.

But anyhow, thanks for looking

Dear Sir, check out 800I siemens config it is the same .