Hi All ,

i have a machine named " Feeler FV 800 " with a control "mitsubishi cnc Meldas M3"

i need to refrance the axis of this machine i don't know how .

i mean when i turn on the machine , it can rotate or move or do anything unless first i have to go the home position of the machine , but i can do it

in case anyone have a machine like it and use it's control please help me .


Ali

Does the machine have a "home" button?

Is this a Mill? If the original machine tool builder programmed it that the axis requires to be homed before it can be run in auto, then there should be a position on the function switch labeled accordingly, rather than letters it may be the universal symbol for homing, like a target bullseye.
Then the home position push buttons held on.
Post a shot of the operator panel if possible.
Al.

on some machine you can go into mdi and put G01 G52 x y z 0 F1.0 but first make sure you are not on a limted switch

wow i solved the problem , and am writing here the solution .

the problem was an over travel in the X axis that prevents the machine from moving .

Ali