|
View Full Version : mastercam post for centroid ? cadchris 03-26-2006, 10:47 AM I recenley upgraded from mastercam v6 to v9 and now the post won't put numbers on my line's like N100 and also it calls for a toolchange everytime it picks up now. what can i change in the post to fix this? Thanks lakeside 03-26-2006, 11:03 AM scriping is something if you don't understand is best left to mastercam if you give them a call I sure they will walk you though it Mike Mattera 04-04-2006, 12:21 PM V9 comes with a Centroid post MPM4. Try that. Mike Mattera cadchris 04-04-2006, 01:49 PM can i find m4p4.pst at? I don't seem to have it! Thanks Mike Mattera 04-04-2006, 02:03 PM Did you install all the posts from your CD? If not re-insert the CD and install the posts. It will put the posts in the C:\Mcam9\Mill\Posts folder. Mike Mattera dbb135 06-30-2006, 06:49 PM The correct post is MPCENM4. This is what I use for my Centroid M400 control. I can email it to you if you would like. Dan cadchris 07-01-2006, 11:12 AM please do at cdevido@aol.com thank you JaneGao 07-04-2006, 07:39 AM you can try it in control ,in Control there is a NC output,you can change them cadchris 07-04-2006, 09:25 AM where is control at? centroid or mastercam? |