I'm passionate about learning anything that would require 4-5 axis machining..or learning to apply Powermill,Mastercam,UG software to do this. Nothing inpaticular..Just wanting to learn something that interests me. I'm a decent person with a high motivation level. The generous sharing of this knowledge would be greatly appreciated.

Italianm28,

I live in Jackson and have 4th and 5th axis programming and operating experence using EdgeCAM and other software. There are others on this board in your local area as well. I once taught CNC programming at a local college (JCC) for a couple of semesters. Welcome to the group.

Wayne

Wayne..thanks for the nicw welcome. I appreciate your reply. If it's not to much of an inconvience for you. Is there a way for me to come and pick your brain on a few things or come down your way and take a look at some of the things your doing.
Or...Any interest in maybe teaching for some $

italianm28,

You have email :)

nt48375@yahoo.com