what software do i need to cam / create g-code for Amada Gemini Laser Machine. I have my 2d .dxf drawn up, but cant do anything with them yet, thanks.

Bulle tx magnet
u told that u hv 2d dxf file
but i think ur machine cant read dxf format
machine reades only machine language
so u can use any cam softwer using in wire EDM machine
it will helps u
u just make a profile in the software
and softer convert it in machine language
and u can send it in machine through DNC or manual data inputor as part programme also
ok
Chreers
RAVIN.

visit once a day in chat room

thank you for your reply. i know the amada gemini laser can not read any .dxf format and that it only reads a machine code(g-code), i pretty much was asking which software i could use to cam or create a profile for the laser, convert the dxf to g-code and allow me to sequence the cuts and such. thank you