Hi All ,

am having an bridgebort machine which is use a Heidenhain Control , but unforunatly i have no operator for the machine ,

only i have the control manual , i have some problems while using the machine.

if you have any experiance with heidenhein control please tel me because i have some questions to run my machine


waiting for your response ,

Ali

I use them for a living, Pleased to help (If I can!)

Regards
Steve

so which TNC control you use?

I have a bridgeport vmc 1000 running on a heidenhain tnc 360
and a dmu 50 evolution running on a heidenhain 426

i uses tnc 355 and tnc 145
both are very user friendly controler

I'm using a tnc 355, - What are your questions, and what tnc are you?

o.k , so my first question is :

is there are any differances between the miscelanuous functions M in the differant TNC models.

so i mean M4 rotate the spindle in TNC 350
what about other TNC


secondly i have a machine Bredigbort i start it and then it's control then am trying to run the spindle but i can't , i don't why.

i follow the steps in the control manual but spindle doesn't rotate , although the last opetaor was always do it easily ,

i feel i have missunderstanding with the machine .

so i just can use the free wheel and move axes to specified poistions , but can't run the spindle .

Air pressure is o.k ,

can you recommend any solutions .

Ali

most of the m codes should be the same.
M3 turns the spinde forward
M4 turns the spindle reverse

But you have to tell it a speed first. When you are in handwheel, press the "tool call" button. enter a speed, press enter, and hit cycle start.
Then enter the M3 and press cycle start.

hope that helps!
chris.

Have you started the drives and referenced the machine? Nothing will work until this has been done

no i didn't refrenced the machine , how to do that

o.k , i did it and the machine now at the referance point.

am using Heidenhein TNC 2500

Hi Ali

which control of heidenhein you are having on your bridgeport. what type of problems you are having with your machine.Have you done the interfacing of your machine with the PC.

regards
Arshad





Hi All ,

am having an bridgebort machine which is use a Heidenhain Control , but unforunatly i have no operator for the machine ,

only i have the control manual , i have some problems while using the machine.

if you have any experiance with heidenhein control please tel me because i have some questions to run my machine


waiting for your response ,

Ali

Is there a key on the controller that say info? Or help your controller manual is most likely loaded in the controller itself

Finally i got the machine manul from one of my friends , all is fine now with the machine , i rotated the spindle , and i moved the axes , the machine is working well.

my problem now , how to interface the machine with the computer , i need a asoftware to send data to the bridgebort machine , how to get it

u can use TNCREMO DNC SOFTWER

and how to get it ?

I need to know that if there is any C.N.C. machine which can cut tapered flange grooves in hot rolling rolls .The taper is from 19 mm to 1.5mm in a depth of about 80mm.Any further information may be provided if asked by any one willing to help.
Dipankar Bhattacharya