we're just starting with Pro/E and there are some parts we'd like to have made. I get all the way to where I want to post, and it fails. The error message is less than informative. Is there any way to get any more information about why it fails to post?
I was trying to use the Haas VF1 post that came with the software.

Are you able to launch the option file generator?

What operating system?

Sorry it took so long to get back to this post.
Yes, we can open the option file generator. We are using windows XP.

For what they charge for Pro-E I would be on the phone to them long before looking elsewhere for help but this is a good place to look for help

We have the academic version, which is fully functional but cheap. Thus support is not part of the deal.

check to make sure the path to the post is set-up right on the software set-up pages also sometime if you just call with a simple question they will still answer but they would not write a post for you Pro-e is a pretty good about that they are one of the better software company

Unterhaus,
What are the issues you are seeing on the screen? There a few ways that this can be an issue with. I would say that if you can open gpost then most likely the problem is in your config pro. Feed me some more info and we can get it going. I also might have a post or two for a haus. We run pro for modeling, drawings, assemblies and manufacturing and dumped maintenance last year. There is sites and people out there that can get you going.