Anyone know if he is still around?

http://www.homecnc.info/

I sent him a couple emails over the last 5 days and haven't gotten any responses. I want to buy one of the 360 servos he's selling.

-Matt

Jeff has taken time off to build him a new home.
I currently am selling the 400 oz in motors that he lists on his web site and has been referrring customers to me at
Camtronics Inc
www.camtronics-cnc.com

I am currently out of the 400 oz in motors but I have a shipment on the way. I should get them by next Friday

I went onto PayPal and sent him $321 for 3 of the 360 in-ozs last week. I went in to work this AM and they were placed on my desk about noon by staff. So I suggest going to PayPal and paying him $107 and giving him the shipping address and you will get the motor a few days later. I guess he is as busy as the rest of us but has been responsive to me. The motors appear to be a few years old (5 or 6) and are probably manufactured now by MOOG (the site is at PolySci but still MOOG). The link below has a PDF for this motor (C23-L50-W30) is my best guess. I plan to contact them to see what a 430 in-oz (C23-L55-W30) as well as what the 360 in-oz would cost new from them.

http://www.polysci.com/docs/moc23series.PDF

R

His last post indicated that he was out of business until 7 March or so.....he didn't indicate the reason.....but if Dan Mauch....says he is the stand-in then I would support that....

I got my plans from him a few months back or so.. Got my build done..

Although got all the hard parts (motors power supply ect) from camtronics:)

b.