i am wondering if anyone has found a place to get setup and operating
instructions for the ih mill that might be more detailed than the original ?
like maybe an rf45 setup manual could be used or something like that,
i don't know , just throwing out a question , i've always been one that
can't read enough on equipment i purchase. just an idea

thanks again

i am wondering if anyone has found a place to get setup and operating
instructions for the ih mill that might be more detailed than the original ?
like maybe an rf45 setup manual could be used or something like that,
i don't know , just throwing out a question , i've always been one that
can't read enough on equipment i purchase. just an idea

thanks again

I have a copy of the RF-45 owner's manual in PDF. I can e-mail it to you if you need.

Thanks Neil , i will take a copy. :D

sweeney24@adelphia.net

Could you possible send a copy to me as well. I am awaiting delivery of my RF-45.

Thanks,
Bob

rcduncan@pacbell.net

Could you send me a copy? I am also waiting for a IH mill.

Thanks in Advance.

Brian

bswiers@wowway.com

Can I also get a PDF copy. Saying you have a pdf maybe like chumming for sharks. Thanks.

(removed e-mail address)

Can I also get a PDF copy. Saying you have a pdf maybe like chumming for sharks. Thanks.

Richard.Henderson@itt.com

FYI, I won't be re responding to requests here anymore... If you need a copy, find the Enco mill/drill forum on Yahoo Groups, register as a member, and look in the files section... you'll find it there.


And also, unless you like spam in your mailbox, try not to post your e-mail address on a public message board, as there are computers running 24/7 scanning the web for e-mail addresses for spam purposes. If you're not getting any yet, trust me you will.

FYI, I won't be re responding to requests here anymore... If you need a copy, find the Enco mill/drill forum on Yahoo Groups, register as a member, and look in the files section... you'll find it there.
http://groups.yahoo.com/group/mill_drill/