|
View Full Version : Hypertherm 1000 Machine Torch Help mattmu 12-12-2005, 01:59 PM Anybody have pictures or diagrams of a Hypertherm Machine torch. Or know what wires do what? Trying to convert a manual to a machine and use hypertherms cnc controls but I am having trouble finding a good diagram of a machine torch. So if anybody has a machine torch laying around perferably disassembled and can take pictures or draw up a diagram and post them I would appreciate it. Thanks matt zoltan 12-12-2005, 02:07 PM Hi, Is there somebody who homebuilt a plasma cutter? I mean the power supply and torch. For me a plasma cutter is far too expensive but I would try to build one as my plan after three cnc machines built is to build a machine from AL extrusions with the possibility to be used as a plasma cnc. I would appreciate at least some guidelines about the schematics of such a device and parameters. Thank you. Zoltan zoltan 12-16-2005, 10:06 AM Nobody can help? At least a place where I can see such a schematics?? Thank you. Zoltan WeCheat 12-16-2005, 07:50 PM The photos I sent you were not what you were looking for? If not please are more specific and I will see what I can do. Greg zoltan 12-17-2005, 12:51 AM Sorry Greg, but I did not get photos. I have received nothing. Where did you send the photos? Thank you. Zoltan WeCheat 12-17-2005, 09:42 AM Take a look here I put them on my site Hypertherm 900 (http://www.WeCheat.com/cnc/cnc.htm) If you need more let me know and I will try to get it Weldtutor 12-17-2005, 12:09 PM Zoltan There is a schematic & video you might be interested in if you are a member of another group. Try the Yahoo Group for Plasmacutting. Look in the "Files" for "Home Brew Plasma" WT zoltan 12-17-2005, 01:36 PM Thank you both. Actually, I am looking for a schematics - the controller of plasma cutter. The pictures are Ok, but do you have also the schematics of the controller/driver? Thank you again. Zoltan PS: I am going to look on Yahoo, but I believe it is the simple schematics with water resistor I have seen yesterday on net. I am looking for something more efficient and electronically controlled. Zoltan WeCheat 12-20-2005, 10:39 PM I had a service/repaire manual sent to me from a rep see if this is what you need Sevice manual for a 1000 (http://www.wecheat.com/cnc/1.htm) zoltan 12-21-2005, 02:12 AM Hi Greg, THANK YOU. This is a huge help. I am getting closer and closer to it. Still, any other piece of information will be highly appreciated. Thank you. Zoltan |