O4001
(PROGRAM NO.=????)
(COMPANY NAME:????)
(PART NAME:????)
(PART NO.& REV:????)
(PROGRAM BY:????)
(DATE-???? /TIME-???? )
(WORK OFFSETS:)
(X0=CENTER OF PART)
(Y0=CENTER OF PART)
(Z0=ON TOP OF PART)
(SET UP NOTES:)
(ROTATE PART 5 DEGREE CCW & LINE UP 2 HOLE)
N1 ( PLUNG OTHER END OF SLOT )
G00 G17 G40 G49 G80 G90

hi everyone, how do i make a template (see up there) in mastercam when i post it out to g-code, so i don't need to type it again, thank you....

Looks Like my Haas post I was just about to ask did you get a copy of mine.

Send me an email we will see waht we can do.