Check at the new CNC Glossary page http://www.cnczone.com/glossary.php please feel free to PM me your words and definitions.

I like it!

I do not have anything terribly important to contribute at this time - but upon browsing the contributions, I was wondering if you should look at the capitalization of CAM.

I know that this is nit-picky and that I myself am in no position to criticize grammar, ( I think that a semicolon is somewhat south of your stomach and somewhat north of the destination) but I thought that I would point it out.

Again, I like the site and thank you for your efforts.
:)
Jason

Will do.