|
View Full Version : Who is going??? CNCadmin 03-14-2003, 12:48 PM Who is going to the WESTECH Tool Show in the Los Angeles Convention Center on March 24-27 ? Are their any shows like this on the east coast? CNCadmin 03-14-2003, 02:30 PM Is there any in NJ area? hardmill 03-14-2003, 09:15 PM i'll be there CNCadmin 03-18-2003, 02:39 PM Hardmill did you get my pm? hardmill 03-18-2003, 09:43 PM If your reffering to the flyers i'd be happy to. JIMMY 03-19-2003, 11:20 PM I am going to WESTECH Turbine 03-24-2003, 09:35 PM EASTEC is the the eastern version of the same. (Springfield Mass.) Go to the SME site (after WESTEC blows over) for info. You would need to camp out coming from NJ. It would be worth it if you're into it. There's usually six very large buldings full. I go every year so I'm not easily impressed. CNCadmin 03-24-2003, 09:37 PM Originally posted by Turbine EASTEC is the the eastern version of the same. (Springfield Mass.) Go to the SME site (after WESTEC blows over) for info. You would need to camp out coming from NJ. It would be worth it if you're into it. There's usually six very large buldings full. I go every year so I'm not easily impressed. How many vendors would you say will be there? hardmill 03-24-2003, 09:59 PM Hey turbine good to see you here Turbine 03-25-2003, 09:51 PM CNCadmin, The site is up. 700 exhibitors www.sme.org/eastec. JIMMY 03-25-2003, 10:10 PM I went today, 3/25/03. The show is full of alot of new products. I spent 7 hours there today. CNCadmin 03-31-2003, 02:16 PM Originally posted by Turbine CNCadmin, The site is up. 700 exhibitors www.sme.org/eastec. http://www.sme.org/cgi-bin/get-event.pl?--000180-000007-008799--SME- |