|
View Full Version : Xylotex controler mcundiff1 09-27-2005, 09:14 PM Hello all, I was looking at getting a Xylotex 3 axis controler for my Taig. I would like to run Mach 2 or 3 with it. I will get the kit with there 287 in/oz motors. Is this a good setup ? Thanks Mitch ................ ger21 09-27-2005, 10:04 PM Is this a good setup ? Thanks Mitch ................ Yep.:) ViperTX 09-27-2005, 10:10 PM :idea: Double Yep! musicmkr 09-28-2005, 06:19 AM It sure is, I've got it running my HF Micro, and it sure get's the job done! DieGuy 09-28-2005, 07:30 AM yep mine with 276 oz/in steps is the treat. Works nicely! I am just getting ready to make the jump to Mach 3. mcundiff1 09-28-2005, 11:19 AM Hey Dieguy; Did you get your motors from AutomationDirect ? Was the system easy to set up ? Trapper14 09-28-2005, 07:39 PM Hey Dieguy; Did you get your motors from AutomationDirect ? Was the system easy to set up ? I got my NEMA 24 274oz steppers from automation direct, I think they are called sure step. Using two single axis Xylotex on them. Just hooked up everything last night works like a charm. Also using AD powersupply. Sean |